Installing Wood Trim is easy. Just remember these six easy steps for a professional installation:

· Check fit and alignment

· Clean surfaces thoroughly

· Apply adhesion promoter

· For large pieces, position and apply top half

· Apply lower half. Small pieces can be done at once

· Press into position while gently warming

Step 1:

Carefully check the fit of each dash piece to assure proper fit and alignment of each part.

Make sure that this is the kit you want -- there is a 25% restocking charge on all returns. There will be no returns without prior authorization or after 30 days. No cash refunds -- company credit only.

DO NOT REMOVE THE RED LINER BACKING AT THIS TIME!

- Installing a wood dash kit or wood trim by Exotic Wood Dash (tm) is easy -- just follow these 6 easy steps! You can do it yourself!

Step 2:

Use alcohol pad (enclosed with kit) to wipe surface clean. THE SURFACE MUST BE PERFECTLY DRY, AND FREE OF ANY OILS OR CONTAMINANTS for the dash kit to adhere properly!

Step 3:

Carefully apply adhesion promoter (enclosed) ONLY TO AREAS TO BE COVERED WITH DASH OVERLAY! Allow to fully dry before proceeding.

Step 4:

For large pieces carefully reposition dash piece in place (see Step 1). Carefully pull back top half and remove red liner. Then starting at the middle and working towards the top, carefully press dash into position. Proceed to Step 5. For small pieces you can remove entire red liner, install and proceed to Step 6.

Step 5:

Gently lift lower portion and remove the rest of the red liner backing. Starting from the middle and working down, carefully press dash into place.

Step 6:

To complete installation. firmly press dash into position while gently warming with hair dryer. DO NOT OVERHEAT DASH.